What what what? Will be gone for 5 months and want to use on our Lincoln car and electric club golf cart has 6 batteries. Hi there, the trickle charger should be fine for the car battery, ie 12volt. Unfortunately the golf buggy as you say has 6 batteries which probably is 6 at 6volts each totalling 36 volts. Therefore your trickle charger would not be sufficient. You would need a charger specifically designed for the buggy.
Cheers Malc. I have a ah battery with a converter connected. Wondered if I could connect a trickle charger with the converter still connected and in use? It is being used on a tricycle powering two soup urns upto w. Any help would be great. Any help would be greatly appreciated. Japanese Used Cars for Sale Carused.
Choose from over 50, used cars. How to import Japanese cars. Some useful related articles. Share this article:. When I connect the charger to my car it flashes red-not charging. Why would it not charge?? Perminant headache with this research so any help would be appreciated.
Although applying a higher charging amperage speeds up this reaction and causes the battery to charge faster, doing so has its costs.
Applying excess charge amperage can generate heat, and may cause off-gassing. In extreme cases, it's possible for a battery to explode. To prevent this, smart trickle chargers can detect the charge level and automatically adjust the amperage. When the battery is very dead, the charger provides more amperage, and it slows as the battery nears full charge so that the electrolyte doesn't off-gas.
In most cases, a trickle charger is more of a luxury than a necessity. However, they aren't expensive, and it's a nice tool to have around. If you can afford to leave your car with your mechanic for a day and have them fully charge your battery—and check out both it and the charging system while they're at it—then that's great.
If you can't afford to be without your car, picking up an inexpensive trickle charger would be a smart move. Make sure you follow safe charging practices and avoid overcharging the battery, especially if you go with a cheap manual trickle charger.
Both chargers can help keep your car battery from dying , but the main difference is electrical current output. A trickle charger slowly outputs current at a low amperage continuously, whereas float chargers supply electrical current only when needed. For this reason, float chargers can stay hooked up to a car battery in storage without the risk of overcharging.
Battery maintainers or battery tenders supply small amounts of current over extended periods to keep a vehicle's battery charged when it falls below a specific voltage. Unlike trickle chargers, battery maintainers automatically enter a standby or float mode to prevent overcharging while connected to a vehicle. Set the switch on the front of the trickle charger to the correct voltage for the battery and then connect the clips to the battery terminals.
Next, plug the charger into an outlet and turn it on. Actively scan device characteristics for identification. Use precise geolocation data. Select personalised content. Create a personalised content profile. Measure ad performance. Select basic ads. Create a personalised ads profile. Select personalised ads. Apply market research to generate audience insights. Measure content performance. Develop and improve products. A trickle charger will deliver a charge that is equal to the batteries rate of self-discharge and should be disconnected once a full charge has been established to avoid overcharging.
A maintenance charger is designed to stay connected to the battery. Once a charge level is set, the charger will automatically turn off and on to maintain the specified charge range. Just make sure that the battery is fully charged before you put it away and you should be able to maintain its charge without a problem. When a battery is being charged, the process of discharge is being reversed. This means that the chemical process that allowed the battery to provide power has to go back to its original state.
The heat from the charging process allows this chemical reversal to happen — however, too much heat, or amperage can create an adverse effect called off-gassing. The gas being released is extremely flammable and unsafe to breathe. When charging any battery, you should be in a well-ventilated area and pay close attention to avoid overcharging.
0コメント